30
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Nanoconfinement induced crystal orientation and large piezoelectric coefficient in vertically aligned P(VDF-TrFE) nanotube array

      research-article

      Read this article at

          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Vertically aligned piezoelectric P(VDF-TrFE) nanotube array comprising nanotubes embedded in anodized alumina membrane matrix without entanglement has been fabricated. It is found that the crystallographic polar axes of the P(VDF-TrFE) nanotubes are oriented along the nanotubes long axes. Such a desired crystal orientation is due to the kinetic selection mechanism for lamellae growth confined in the nanopores. The preferred crystal orientation in nanotubes leads to huge piezoelectric coefficients of the P(VDF-TrFE). The piezoelectric strain and voltage coefficients of P(VDF-TrFE) nanotube array are observed to be 1.97 and 3.40 times of those for conventional spin coated film. Such a significant performance enhancement is attributed to the well-controlled polarization orientation, the elimination of the substrate constraint, and the low dielectric constant of the nanotube array. The P(VDF-TrFE) nanotube array exhibiting the unique structure and outstanding piezoelectric performance is promising for wide applications, including various electrical devices and electromechanical sensors and transducers.

          Related collections

          Most cited references13

          • Record: found
          • Abstract: found
          • Article: not found

          Direct-write piezoelectric polymeric nanogenerator with high energy conversion efficiency.

          Nanogenerators capable of converting energy from mechanical sources to electricity with high effective efficiency using low-cost, nonsemiconducting, organic nanomaterials are attractive for many applications, including energy harvesters. In this work, near-field electrospinning is used to direct-write poly(vinylidene fluoride) (PVDF) nanofibers with in situ mechanical stretch and electrical poling characteristics to produce piezoelectric properties. Under mechanical stretching, nanogenerators have shown repeatable and consistent electrical outputs with energy conversion efficiency an order of magnitude higher than those made of PVDF thin films. The early onset of the nonlinear domain wall motions behavior has been identified as one mechanism responsible for the apparent high piezoelectricity in nanofibers, rendering them potentially advantageous for sensing and actuation applications.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            1.6 V nanogenerator for mechanical energy harvesting using PZT nanofibers.

            Energy harvesting technologies that are engineered to miniature sizes, while still increasing the power delivered to wireless electronics, (1, 2) portable devices, stretchable electronics, (3) and implantable biosensors, (4, 5) are strongly desired. Piezoelectric nanowire- and nanofiber-based generators have potential uses for powering such devices through a conversion of mechanical energy into electrical energy. (6) However, the piezoelectric voltage constant of the semiconductor piezoelectric nanowires in the recently reported piezoelectric nanogenerators (7-12) is lower than that of lead zirconate titanate (PZT) nanomaterials. Here we report a piezoelectric nanogenerator based on PZT nanofibers. The PZT nanofibers, with a diameter and length of approximately 60 nm and 500 microm, were aligned on interdigitated electrodes of platinum fine wires and packaged using a soft polymer on a silicon substrate. The measured output voltage and power under periodic stress application to the soft polymer was 1.63 V and 0.03 microW, respectively.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Flexible high-output nanogenerator based on lateral ZnO nanowire array.

              We report here a simple and effective approach, named scalable sweeping-printing-method, for fabricating flexible high-output nanogenerator (HONG) that can effectively harvesting mechanical energy for driving a small commercial electronic component. The technique consists of two main steps. In the first step, the vertically aligned ZnO nanowires (NWs) are transferred to a receiving substrate to form horizontally aligned arrays. Then, parallel stripe type of electrodes are deposited to connect all of the NWs together. Using a single layer of HONG structure, an open-circuit voltage of up to 2.03 V and a peak output power density of approximately 11 mW/cm(3) have been achieved. The generated electric energy was effectively stored by utilizing capacitors, and it was successfully used to light up a commercial light-emitting diode (LED), which is a landmark progress toward building self-powered devices by harvesting energy from the environment. This research opens up the path for practical applications of nanowire-based piezoelectric nanogeneragtors for self-powered nanosystems.
                Bookmark

                Author and article information

                Journal
                Sci Rep
                Sci Rep
                Scientific Reports
                Nature Publishing Group
                2045-2322
                12 May 2015
                2015
                : 5
                : 09790
                Affiliations
                [1 ]Institute of Materials Research and Engineering (IMRE), A* STAR (Agency for Science, Technology and Research) 3 Research Link, 117602 (Singapore)
                [2 ]Department of Mechanical Engineering National University of Singapore Kent Ridge , 119260 (Singapore)
                Author notes
                Article
                srep09790
                10.1038/srep09790
                4434347
                25966301
                33a07cd8-84d2-4adb-b8b8-91c683cba5bf
                Copyright © 2015, Macmillan Publishers Limited. All rights reserved

                This work is licensed under a Creative Commons Attribution 4.0 International License. The images or other third party material in this article are included in the article's Creative Commons license, unless indicated otherwise in the credit line; if the material is not included under the Creative Commons license, users will need to obtain permission from the license holder in order to reproduce the material. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/

                History
                : 26 January 2015
                : 10 March 2015
                Categories
                Article

                Uncategorized
                Uncategorized

                Comments

                Comment on this article