30
views
0
recommends
+1 Recommend
1 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      P(VDF-TrFE)/ZrO2 Polymer-Composites for X-ray Shielding

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Poly(vinylidene fluoride – tryfluorethylene) [P(VDF-TrFE)] copolymers were mixed with zirconia nanoparticles. The investigation was conducted with the intention to produce nanocompounds with potential to be used as protective patient shielding in radiological procedures. Polymer based nanocomposites with 1, 2, 3, 5 and 10 wt% of ZrO2 nanoparticles were prepared using sol-gel route with zirconium butoxide as the precursor for zirconium oxide nanoclusters. UV-Vis and FTIR spectrometry and differential scanning calorimetry (DSC) were used to characterize the composite samples. We observed a more homogeneous distribution of ZrO2 nanoparticles encapsulated by methyl methacrylate (MMA) into the polymeric matrix, when compared to composites made without the use of surface modifiers from methacrylate group. Apparently, this property is related to the absence of the strong MMA absorption band at 1745 cm-1, attributed to C=O bond, in the P(VDF-TrFE)/ZrO2-MMA nanocomposites. The radiation damage due to high dose exposuring was performed for gamma doses ranging from 100 kGy to 1,000 kGy. The radiation shielding characterization conducted using x-rays with effective energy of 40 keV has demonstrated that composites with 10% of ZrO2,and only 1.0 mm thick, can attenuate 60% of the x-rays beam.

          Related collections

          Most cited references49

          • Record: found
          • Abstract: found
          • Article: not found

          Ferroelectric polymers.

          A Lovinger (1983)
          Piezoelectricity and pyroelectricity, traditionally encountered in certain single crystals and ceramics, have now also been documented in a number of polymers. Recently, one such polymer-poly(vinylidene fluoride)-and some of its copolymers have been shown to be ferroelectric as well. The extraordinary molecular and supermolecular structural requirements for ferroelectric behavior in polymers are discussed in detail, with particular emphasis on poly(vinylidene fluoride). Piezoelectric, pyroelectric, and ferroelectric properties are also briefly reviewed, as are some promising applications of such polymers.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Polymer-composite materials for radiation protection.

            Unwanted exposures to high-energy or ionizing radiation can be hazardous to health. Prolonged or accumulated radiation dosage from either particle-emissions such as alpha/beta, proton, electron, neutron emissions, or high-energy electromagnetic waves such as X-rays/γ rays, may result in carcinogenesis, cell mutations, organ failure, etc. To avoid occupational hazards from these kinds of exposures, researchers have traditionally used heavy metals or their composites to attenuate the radiation. However, protective gear made of heavy metals are not only cumbersome but also are capable of producing more penetrative secondary radiations which requires additional shielding, increasing the cost and the weight factor. Consequently, significant research efforts have been focused toward designing efficient, lightweight, cost-effective, and flexible shielding materials for protection against radiation encountered in various industries (aerospace, hospitals, and nuclear reactors). In this regard, polymer composites have become attractive candidates for developing materials that can be designed to effectively attenuate photon or particle radiation. In this paper, we review the state-of-the-art of polymer composites reinforced with micro/nanomaterials, for their use as radiation shields.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Preparation and Characterization of Mesoporous Zirconia Made by Using a Poly (methyl methacrylate) Template

              Superfine powders of poly (methyl methacrylate) (PMMA) have been prepared by means of an emulsion polymerization method. These have been used as templates in the synthesis of tetragonal phase mesoporous zirconia by the sol–gel method, using zirconium oxychloride and oxalic acid as raw materials. The products have been characterized by infrared spectroscopy, X-ray diffraction analysis, transmission electron microscopy, N2adsorption-desorption isotherms, and pore size distribution. The results indicate that the average pore size was found to be 3.7 nm.
                Bookmark

                Author and article information

                Contributors
                Role: ND
                Role: ND
                Role: ND
                Role: ND
                Journal
                mr
                Materials Research
                Mat. Res.
                ABM, ABC, ABPol
                1980-5373
                April 2016
                : 19
                : 2
                : 426-433
                Affiliations
                [1 ] Universidade Federal de Minas Gerais Brazil
                [2 ] Universidade Federal de Minas Gerais Brazil
                Article
                S1516-14392016000200426
                10.1590/1980-5373-MR-2015-0576
                b1e32ffd-2023-4cd0-b87d-61401c3d9d20

                This work is licensed under a Creative Commons Attribution 4.0 International License.

                History
                Product

                SciELO Brazil

                Self URI (journal page): http://www.scielo.br/scielo.php?script=sci_serial&pid=1516-1439&lng=en
                Categories
                ENGINEERING, CHEMICAL
                MATERIALS SCIENCE, MULTIDISCIPLINARY
                METALLURGY & METALLURGICAL ENGINEERING

                General materials science,General engineering
                P(VDF-TrFE)/ZrO2- MMA polymer composites,ZrO2 nanoparticles,Radiation protective shielding

                Comments

                Comment on this article