Conformal quantum dot–SnO ₂ layers as electron transporters for efficient perovskite solar cells

Abstract

Improvements to perovskite solar cells (PSCs) have focused on increasing their power conversion efficiency (PCE) and operational stability and maintaining high performance upon scale-up to module sizes. We report that replacing the commonly used mesoporous–titanium dioxide electron transport layer (ETL) with a thin layer of polyacrylic acid–stabilized tin(IV) oxide quantum dots (paa-QD-SnO ₂ ) on the compact–titanium dioxide enhanced light capture and largely suppressed nonradiative recombination at the ETL–perovskite interface. The use of paa-QD-SnO ₂ as electron-selective contact enabled PSCs (0.08 square centimeters) with a PCE of 25.7% (certified 25.4%) and high operational stability and facilitated the scale-up of the PSCs to larger areas. PCEs of 23.3, 21.7, and 20.6% were achieved for PSCs with active areas of 1, 20, and 64 square centimeters, respectively.

Tailoring tin oxide layers

Mesoporous titanium dioxide is commonly used as the electron transport layer in perovskite solar cells, but electron transport layers based on tin(IV) oxide quantum dots could be more efficient, with a better-aligned conduction band and a higher carrier mobility. Kim et al . show that such quantum dots could conformally coat a textured fluorine-doped tin oxide electrode when stabilized with polyacrylic acid. Improved light trapping and reduced nonradiative recombination resulted in a certified power conversion efficiency of 25.4% and high operational stability. In larger-area minimodules, active areas as high as 64 square centimeters maintained certified power conversion efficiencies of more than 20%. —PDS

Abstract

Polymer-stabilized tin oxide nanoparticles suppress recombination at the electron-transport layer–perovskite interface.