Assessment of the ability of roadside vegetation to remove particulate matter from the urban air

Emissions of metals and other particle-phase species from on-road motor vehicles were measured in two tunnels in Milwaukee, WI during the summer of 2000 and winter of 2001. Emission factors were calculated from measurements of fine (PM2.5) and coarse (PM10) particulate matter at tunnel entrances and exits, and effects of fleet composition and season were investigated. Cascade impactors (MOUDI) were used to obtain size-resolved metal emission rates. Metals were quantified with inductively-coupled plasma mass spectrometry (ICP-MS) and X-ray fluorescence (XRF). PM10 emission rates ranged from 38.7 to 201 mg km(-1) and were composed mainly of organic carbon (OC, 30%), inorganic ions (sulfate, chloride, nitrate, ammonium, 20%), metals (19%), and elemental carbon (EC, 9.3%). PM10 metal emissions were dominated by crustal elements Si, Fe, Ca, Na, Mg, Al, and K, and elements associated with tailpipe emissions and brake and tire wear, including Cu, Zn, Sb, Ba, Pb, and S. Metals emitted in PM2.5 were lower (11.6% of mass). Resuspension of roadway dust was dependent on weather and road surface conditions, and increased emissions were related to higher traffic volumes and fractions of heavy trucks. Emission of noble metals from catalytic converters appeared to be impacted by the presence of older vehicles. Elements related to brake wear were impacted by enriched road dust resuspension, but correlations between these elements in PM2.5 indicate that direct brake wear emissions are also important. A submicrometer particle mode was observed in the emissions of Pb, Ca, Fe, and Cu.

Tire-tread material has a zinc (Zn) content of about 1 wt %. The quantity of tread material lost to road surfaces by abrasion has not been well characterized. Two approaches were used to assess the magnitude of this nonpoint source of Zn in the U.S. for the period 1936-1999. In the first approach, tread-wear rates from the automotive engineering literature were used in conjunction with vehicle distance-driven data from the U.S. Department of Transportation to determine Zn releases. A second approach calculated this source term from the volume of tread lost during lifetime tire wear. These analyses showed that the quantity of Zn released by tire wear in the mid-1990s was of the same magnitude as that released from waste incineration. For 1999, the quantity of Zn released by tire wear in the U.S. is estimated to be 10 000-11 000 metric tons. A specific case study focused on Zn sources and sinks in an urban-suburban watershed (Lake Anne) in the Washington, DC, metropolitan area for a time period of the late 1990s. The atmospheric flux of total Zn (wet deposition) to the watershed was 2 microg/cm2/yr. The flux of Zn to the watershed estimated from tire wear was 42 microg/cm2/yr. The measured accumulation rate of total Zn in age-dated sediment cores from Lake Anne was 27 microg/cm2/yr. These data suggest that tire-wear Zn inputs to urban-suburban watersheds can be significantly greater than atmospheric inputs, although the watershed appears to retain appreciable quantities of vehicular Zn inputs.