0
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: not found

      Controlled self-assembly of Ni foam supported poly(ethyleneimine)/reduced graphene oxide three-dimensional composite electrodes with remarkable synergistic effects for efficient oxygen evolution

      Read this article at

      ScienceOpenPublisher
      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Ni foam supported PEI/RGO 3-D composite electrodes were controllably self-assembled, showing superior OER catalytic performance attributed to remarkable synergistic interactions.

          Abstract

          Three-dimensional (3-D) composite oxygen evolution electrodes with synergistic effects are promising to significantly boost the efficiency of the oxygen evolution reaction (OER). However, their fabrication presents great challenges. Herein, for the first time we show that layer-by-layer (LbL) self-assembly on 3-D substrates can be employed to controllably fabricate 3-D composite electrodes. Ni foam (NF) supported poly(ethyleneimine) (PEI)/reduced graphene oxide (RGO) multilayers fabricated viathis approach have tunable catalytic properties. The optimum one achieves the current density of 10 mA cm −2at an overpotential of 322 mV, which is lower than those of most reported transition metal-based OER catalysts and non-metal ones as well as those of state-of-the-art Ir/C, Ru/C, IrO 2/C, and RuO 2measured under the same conditions (0.1 M KOH). It shows a Tafel slope of 78 mV dec −1, which is among the lowest reported for transition metal-based OER catalysts and non-metal ones and comparable to or even lower than that of state-of-the-art Ir and Ru-based ones measured in 0.1 M KOH. In addition, this electrode exhibits a potential increase from 0.55 V to 0.58 V vs.SCE after 18.8 h of chronopotentiometry testing at 10 mA cm −2and retains 85.8% of the current density at 1.0 V vs.SCE after 350 CV cycles, revealing its good stability. The high catalytic performance could be attributed to in situformed Ni(OH) 2with RGO-promoted activity, high-density CO rich edge-exposed RGO nanosheets, and the covalently crosslinked multilayer structure of chemically stable RGO nanosheets. All of these properties arise from synergistic interactions between NF, PEI, and RGO. This work offers a facile, mild, controllable, and economical strategy to synergistically assemble conventional poor OER catalysts for low-cost, highly active, and durable 3-D OER electrodes. It also provides scientific insight into the mechanism for the superior and tunable OER catalytic activity, which is critical for further improving the OER catalytic performance.

          Related collections

          Most cited references15

          • Record: found
          • Abstract: found
          • Article: not found

          A perovskite oxide optimized for oxygen evolution catalysis from molecular orbital principles.

          The efficiency of many energy storage technologies, such as rechargeable metal-air batteries and hydrogen production from water splitting, is limited by the slow kinetics of the oxygen evolution reaction (OER). We found that Ba(0.5)Sr(0.5)Co(0.8)Fe(0.2)O(3-δ) (BSCF) catalyzes the OER with intrinsic activity that is at least an order of magnitude higher than that of the state-of-the-art iridium oxide catalyst in alkaline media. The high activity of BSCF was predicted from a design principle established by systematic examination of more than 10 transition metal oxides, which showed that the intrinsic OER activity exhibits a volcano-shaped dependence on the occupancy of the 3d electron with an e(g) symmetry of surface transition metal cations in an oxide. The peak OER activity was predicted to be at an e(g) occupancy close to unity, with high covalency of transition metal-oxygen bonds.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Benchmarking heterogeneous electrocatalysts for the oxygen evolution reaction.

            Objective evaluation of the activity of electrocatalysts for water oxidation is of fundamental importance for the development of promising energy conversion technologies including integrated solar water-splitting devices, water electrolyzers, and Li-air batteries. However, current methods employed to evaluate oxygen-evolving catalysts are not standardized, making it difficult to compare the activity and stability of these materials. We report a protocol for evaluating the activity, stability, and Faradaic efficiency of electrodeposited oxygen-evolving electrocatalysts. In particular, we focus on methods for determining electrochemically active surface area and measuring electrocatalytic activity and stability under conditions relevant to an integrated solar water-splitting device. Our primary figure of merit is the overpotential required to achieve a current density of 10 mA cm(-2) per geometric area, approximately the current density expected for a 10% efficient solar-to-fuels conversion device. Utilizing the aforementioned surface area measurements, one can determine electrocatalyst turnover frequencies. The reported protocol was used to examine the oxygen-evolution activity of the following systems in acidic and alkaline solutions: CoO(x), CoPi, CoFeO(x), NiO(x), NiCeO(x), NiCoO(x), NiCuO(x), NiFeO(x), and NiLaO(x). The oxygen-evolving activity of an electrodeposited IrO(x) catalyst was also investigated for comparison. Two general observations are made from comparing the catalytic performance of the OER catalysts investigated: (1) in alkaline solution, every non-noble metal system achieved 10 mA cm(-2) current densities at similar operating overpotentials between 0.35 and 0.43 V, and (2) every system but IrO(x) was unstable under oxidative conditions in acidic solutions.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Homogeneously dispersed multimetal oxygen-evolving catalysts.

              Earth-abundant first-row (3d) transition metal-based catalysts have been developed for the oxygen-evolution reaction (OER); however, they operate at overpotentials substantially above thermodynamic requirements. Density functional theory suggested that non-3d high-valency metals such as tungsten can modulate 3d metal oxides, providing near-optimal adsorption energies for OER intermediates. We developed a room-temperature synthesis to produce gelled oxyhydroxides materials with an atomically homogeneous metal distribution. These gelled FeCoW oxyhydroxides exhibit the lowest overpotential (191 millivolts) reported at 10 milliamperes per square centimeter in alkaline electrolyte. The catalyst shows no evidence of degradation after more than 500 hours of operation. X-ray absorption and computational studies reveal a synergistic interplay between tungsten, iron, and cobalt in producing a favorable local coordination environment and electronic structure that enhance the energetics for OER.
                Bookmark

                Author and article information

                Contributors
                Journal
                JMCAET
                Journal of Materials Chemistry A
                J. Mater. Chem. A
                Royal Society of Chemistry (RSC)
                2050-7488
                2050-7496
                2017
                2017
                : 5
                : 3
                : 1201-1210
                Affiliations
                [1 ]Institute for Clean Energy & Advanced Materials
                [2 ]Faculty of Materials & Energy
                [3 ]Southwest University
                [4 ]Chongqing 400715
                [5 ]China
                Article
                10.1039/C6TA08972K
                9c0a4078-112e-407c-a7a7-a1b5a2de8b90
                © 2017
                History

                Comments

                Comment on this article