20
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Shear Stress Affects Biofilm Structure and Consequently Current Generation of Bioanode in Microbial Electrochemical Systems (MESs)

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Shear stress is an important factor that affects the formation and structure of anode biofilms, which are strongly related to the extracellular electron transfer phenomena and bioelectric performance of bioanodes. Here, we show that using nitrogen sparging to induce shear stress during anode biofilm formation increases the linear sweep voltammetry peak current density of the mature anode biofilm from 2.37 ± 0.15 to 4.05 ± 0.25 A/m 2. Electrochemical impedance spectroscopy results revealed that the shear-stress-enriched anode biofilm had a low charge transfer resistance of 46.34 Ω compared to that of the unperturbed enriched anode biofilm (72.2 Ω). Confocal laser scanning microscopy observations showed that the shear-stress-enriched biofilms were entirely viable, whereas the unperturbed enriched anode biofilm consisted of a live outer layer covering a dead inner-core layer. Based on biomass and community analyses, the shear-stress-enriched biofilm had four times the biofilm density (136.0 vs. 27.50 μg DNA/cm 3) and twice the relative abundance of Geobacteraceae (over 80 vs. 40%) in comparison with those of the unperturbed enriched anode biofilm. These results show that applying high shear stress during anode biofilm enrichment can result in an entirely viable and dense biofilm with a high relative abundance of exoelectrogens and, consequently, better performance.

          Related collections

          Most cited references36

          • Record: found
          • Abstract: not found
          • Article: not found

          Electricity Production by Geobacter sulfurreducens Attached to Electrodes

            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Power generation in fed-batch microbial fuel cells as a function of ionic strength, temperature, and reactor configuration.

            Power density, electrode potential, coulombic efficiency, and energy recovery in single-chamber microbial fuel cells (MFCs) were examined as a function of solution ionic strength, electrode spacing and composition, and temperature. Increasing the solution ionic strength from 100 to 400 mM by adding NaCl increased power output from 720 to 1330 mW/m2. Power generation was also increased from 720 to 1210 mW/m2 by decreasing the distance between the anode and cathode from 4to 2 cm. The power increases due to ionic strength and electrode spacing resulted from a decrease in the internal resistance. Power output was also increased by 68% by replacing the cathode (purchased from a manufacturer) with our own carbon cloth cathode containing the same Pt loading. The performance of conventional anaerobic treatment processes, such as anaerobic digestion, are adversely affected by temperatures below 30 degrees C. However, decreasing the temperature from 32 to 20 degrees C reduced power output by only 9%, primarily as a result of the reduction of the cathode potential. Coulombic efficiencies and overall energy recovery varied as a function of operating conditions, but were a maximum of 61.4 and 15.1% (operating conditions of 32 degrees C, carbon paper cathode, and the solution amended with 300 mM NaCl). These results, which demonstrate that power densities can be increased to over 1 W/m2 by changing the operating conditions or electrode spacing, should lead to further improvements in power generation and energy recovery in single-chamber, air-cathode MFCs.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              The essential role of hydrodynamic shear force in the formation of biofilm and granular sludge.

              Biofilm and granular sludge processes are promising biotechnology for wastewater treatment. The formation, structure and metabolism of immobilized microbial community are associated very closely with hydrodynamic shear force in reactors. Therefore, this paper attempts to review the essential role of shear force in the formation and performance of biofilm and granular sludge. More compact, stable and denser biofilms, aerobic and anaerobic granules form at relatively higher hydrodynamic shear force. It is clearly shown that shear force has significant influences on the structure, mass transfer, production of exopolysaccharides, metabolic/genetic behaviours of biofilms, aerobic and anaerobic granules. In an engineering sense, hydrodynamic shear force can be manipulated, as a control parameter, to enhance microbial granulation process. It can be concluded that the knowledge regarding the effects of hydrodynamic shear force on biofilms and granules is far from complete and much research is still needed to fully understand the relevant mechanisms. Some of these future research niches are therefore outlined.
                Bookmark

                Author and article information

                Contributors
                Journal
                Front Microbiol
                Front Microbiol
                Front. Microbiol.
                Frontiers in Microbiology
                Frontiers Media S.A.
                1664-302X
                06 March 2019
                2019
                : 10
                : 398
                Affiliations
                State Key Laboratory of Clean Energy, Department of Energy Engineering, Zhejiang University , Hangzhou, China
                Author notes

                Edited by: Juan Liu, Peking University, China

                Reviewed by: Xin Wang, Nankai University, China; Luyan Zulie Ma, Institute of Microbiology (CAS), China

                *Correspondence: Shaoan Cheng, shaoancheng@ 123456zju.edu.cn

                This article was submitted to Microbiotechnology, Ecotoxicology and Bioremediation, a section of the journal Frontiers in Microbiology

                Article
                10.3389/fmicb.2019.00398
                6415583
                30894842
                8f3917c1-2277-4d71-a99c-69d3df8e0356
                Copyright © 2019 Yang, Cheng, Li, Sun and Huang.

                This is an open-access article distributed under the terms of the Creative Commons Attribution License (CC BY). The use, distribution or reproduction in other forums is permitted, provided the original author(s) and the copyright owner(s) are credited and that the original publication in this journal is cited, in accordance with accepted academic practice. No use, distribution or reproduction is permitted which does not comply with these terms.

                History
                : 01 October 2018
                : 15 February 2019
                Page count
                Figures: 5, Tables: 0, Equations: 0, References: 43, Pages: 8, Words: 0
                Categories
                Microbiology
                Original Research

                Microbiology & Virology
                anode biofilm,shear stress,anode performance,viability,microbial community
                Microbiology & Virology
                anode biofilm, shear stress, anode performance, viability, microbial community

                Comments

                Comment on this article