Household Biogas Digesters—A Review

The use of biomass to provide energy has been fundamental to the development of civilisation. In recent times pressures on the global environment have led to calls for an increased use of renewable energy sources, in lieu of fossil fuels. Biomass is one potential source of renewable energy and the conversion of plant material into a suitable form of energy, usually electricity or as a fuel for an internal combustion engine, can be achieved using a number of different routes, each with specific pros and cons. A brief review of the main conversion processes is presented, with specific regard to the production of a fuel suitable for spark ignition gas engines.

Microalgae enhance the removal of nutrients, organic contaminants, heavy metals, and pathogens from domestic wastewater and furnish an interesting raw material for the production of high-value chemicals (algae metabolites) or biogas. Photosynthetic oxygen production also reduces the need for external aeration, which is especially advantageous for the treatment of hazardous pollutants that must be biodegraded aerobically but might volatilize during mechanical aeration. Recent studies have therefore shown that when proper methods for algal selection and cultivation are used, it is possible to use microalgae to produce the O(2) required by acclimatized bacteria to biodegrade hazardous pollutants such as polycyclic aromatic hydrocarbons, phenolics, and organic solvents. Well-mixed photobioreactors with algal biomass recirculation are recommended to protect the microalgae from effluent toxicity and optimize light utilization efficiency. The optimum biomass concentration to maintain in the system depends mainly on the light intensity and the reactor configuration: At low light intensity, the biomass concentration should be optimized to avoid mutual shading and dark respiration whereas at high light intensity, a high biomass concentration can be useful to protect microalgae from light inhibition and optimize the light/dark cycle frequency. Photobioreactors can be designed as open (stabilization ponds or high rate algal ponds) or enclosed (tubular, flat plate) systems. The latter are generally costly to construct and operate but more efficient than open systems. The best configuration to select will depend on factors such as process safety, land cost, and biomass use. Biomass harvest remains a limitation but recent progresses have been made in the selection of flocculating strains, the application of bioflocculants, or the use of immobilized biomass systems.

Food waste collected in the City of San Francisco, California, was characterized for its potential for use as a feedstock for anaerobic digestion processes. The daily and weekly variations of food waste composition over a two-month period were measured. The anaerobic digestibility and biogas and methane yields of the food waste were evaluated using batch anaerobic digestion tests performed at 50 degrees C. The daily average moisture content (MC) and the ratio of volatile solids to total solids (VS/TS) determined from a week-long sampling were 70% and 83%, respectively, while the weekly average MC and VS/TS were 74% and 87%, respectively. The nutrient content analysis showed that the food waste contained well balanced nutrients for anaerobic microorganisms. The methane yield was determined to be 348 and 435 mL/gVS, respectively, after 10 and 28 days of digestion. The average methane content of biogas was 73%. The average VS destruction was 81% at the end of the 28-day digestion test. The results of this study indicate that the food waste is a highly desirable substrate for anaerobic digesters with regards to its high biodegradability and methane yield.