Sensitivity Characteristics of Fabry-Perot Pressure Sensors Based on Hollow-Core Microstructured Fibers

Photonic bandgap structures use the principle of interference to reflect radiation. Reflection from photonic bandgap structures has been demonstrated in one, two and three dimensions and various applications have been proposed. Early work in hollow-core photonic bandgap fibre technology used a hexagonal structure surrounding the air core; this fibre was the first demonstration of light guided inside an air core of a photonic bandgap fibre. The potential benefits of guiding light in air derive from lower Rayleigh scattering, lower nonlinearity and lower transmission loss compared to conventional waveguides. In addition, these fibres offer a new platform for studying nonlinear optics in gases. Owing largely to challenges in fabrication, the early air-core fibres were only available in short lengths, and so systematic studies of loss were not possible. More recently, longer lengths of fibre have become available with reported losses of 1,000 dB km(-1). We report here the fabrication and characterization of long lengths of low attenuation photonic bandgap fibre. Attenuation of less than 30 dB km(-1) over a wide transmission window is observed with minimum loss of 13 dB km(-1) at 1,500 nm, measured on 100 m of fibre. Coupling between surface and core modes of the structure is identified as an important contributor to transmission loss in hollow-core photonic bandgap fibres.

We report the fabrication and characterization of a new type of hollow-core photonic crystal fiber based on large-pitch (approximately 12 microm) kagome lattice cladding. The optical characteristics of the 19-cell, 7-cell, and single-cell core defect fibers include broad optical transmission bands covering the visible and near-IR parts of the spectrum with relatively low loss and low chromatic dispersion, no detectable surface modes and high confinement of light in the core. Various applications of such a novel fiber are also discussed, including gas sensing, quantum optics, and high harmonic generation.

A fiber-optic Fabry-Perot interferometer was constructed by splicing a short length of photonic crystal fiber to a standard single-mode fiber. The photonic crystal fiber functions as a Fabry-Perot cavity and serves as a direct sensing probe without any additional components. Its pressure and temperature responses in the range of 0-40 MPa and 25°C-700°C were experimentally studied. The proposed sensor is easy to fabricate, potentially low-cost, and compact in size, which makes it very attractive for high-pressure and high-temperature sensing applications.