10
views
0
recommends
+1 Recommend
1 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Twenty-four-month clinical performance of different universal adhesives in etch-and-rinse, selective etching and self-etch application modes in NCCL – a randomized controlled clinical trial

      research-article

      Read this article at

      ScienceOpenPublisherPMC
      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Objective

          The aim of this randomized, controlled, prospective clinical trial was to evaluate the performances of two different universal adhesives and one etch-rinse adhesive for restoration of non-carious cervical lesions (NCCLs).

          Material and Methods

          Twenty patients with at least seven NCCLs were enrolled. Lesions were divided into seven groups according to adhesive systems and application modes: GSE: GLUMA Universal-self-etch, GSL: GLUMA Universal-selective etching, GER: GLUMA Universal-etch-and-rinse, ASE: All-Bond Universal-self-etch, ASL: All-Bond Universal-selective etching, AER: All-Bond Universal-etch-and-rinse, SBE (Control): Single Bond2-etch-and-rinse. A total of 155 NCCLs were restored with a nano hybrid composite (Tetric N-Ceram). Restorations were scored with regard to retention, marginal discoloration, marginal adaptation, recurrent caries and post-operative sensitivity using modified United States Public Health Service (USPHS) criteria after one week, 6, 12 and 24 months. Statistical evaluations were performed using Chi-square tests (p=0.05).

          Results

          The recall rate was 81.9% after the 24-month follow-up. The cumulative retention rates for self-etch groups (GSE: 72.2%, ASE:75%) were significantly lower than other experimental groups (GSL: 93.7%, GER: 100%, ASL: 94.1%, AER: 100%, SBE: 100%) at the 24-month follow-up (p<0.05). Regarding marginal adaptation and marginal discoloration, GSE and ASE groups demonstrated more bravo scores after 6 and 12-month observations but differences were not significant (p>0.05). Only one restoration from ASL group demonstrated post-operative sensitivity at 6 and 12-month observations. No secondary caries was observed on the restorations at any recall. At the end of 24-month observations, no significant differences were detected among groups regarding any of the criteria assessed, except retention.

          Conclusion

          GLUMA Universal and All-Bond Universal showed better results in etch-and-rinse and selective etching mode compared to the self-etch mode regarding retention. Etch-and-rinse and selective etching application modes of the current universal adhesives tended to provide better clinical outcomes considering the criteria evaluated at the end of 24-month evaluation.

          Related collections

          Most cited references45

          • Record: found
          • Abstract: found
          • Article: not found

          A critical review of the durability of adhesion to tooth tissue: methods and results.

          The immediate bonding effectiveness of contemporary adhesives is quite favorable, regardless of the approach used. In the long term, the bonding effectiveness of some adhesives drops dramatically, whereas the bond strengths of other adhesives are more stable. This review examines the fundamental processes that cause the adhesion of biomaterials to enamel and dentin to degrade with time. Non-carious class V clinical trials remain the ultimate test method for the assessment of bonding effectiveness, but in addition to being high-cost, they are time- and labor-consuming, and they provide little information on the true cause of clinical failure. Therefore, several laboratory protocols were developed to predict bond durability. This paper critically appraises methodologies that focus on chemical degradation patterns of hydrolysis and elution of interface components, as well as mechanically oriented test set-ups, such as fatigue and fracture toughness measurements. A correlation of in vitro and in vivo data revealed that, currently, the most validated method to assess adhesion durability involves aging of micro-specimens of biomaterials bonded to either enamel or dentin. After about 3 months, all classes of adhesives exhibited mechanical and morphological evidence of degradation that resembles in vivo aging effects. A comparison of contemporary adhesives revealed that the three-step etch-and-rinse adhesives remain the 'gold standard' in terms of durability. Any kind of simplification in the clinical application procedure results in loss of bonding effectiveness. Only the two-step self-etch adhesives approach the gold standard and do have some additional clinical benefits.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Buonocore memorial lecture. Adhesion to enamel and dentin: current status and future challenges.

            Bonding to tooth tissue can be achieved through an "etch&rinse," "self-etch" or "glass-ionomer" approach. In this paper, the basic bonding mechanism to enamel and dentin of these three approaches is demonstrated by means of ultramorphological and chemical characterization of tooth-biomaterial interfacial interactions. Furthermore, bond-strength testing and measurement of marginal-sealing effectiveness (the two most commonly employed methodologies to determine "bonding effectiveness" in the laboratory) are evaluated upon their value and relevance in predicting clinical performance. A new dynamic methodology to test biomaterial-tooth bonds in a fatigue mode is introduced with a recently developed micro-rotary fatigue-testing device. Eventually, today's adhesives will be critically weighted upon their performance in diverse laboratory studies and clinical trials. Special attention has been given to the benefits/drawbacks of an etch&rinse versus a self-etch approach and the long-term performance of these adhesives. Correlating data gathered in the laboratory with clinical results clearly showed that laboratory research CAN predict clinical effectiveness. Although there is a tendency to simplify bonding procedures, the data presented confirm that conventional three-step etch&rinse adhesives still perform most favorably and are most reliable in the long-term. Nevertheless, a self-etch approach may have the best future perspective. Clinically, when adhesives no longer require an "etch&rinse" step, the application time, and probably more importantly, the technique-sensitivity are substantially reduced. Especially "mild," two-step self-etch adhesives that bond through a combined micromechanical and chemical interaction with tooth tissue closely approach conventional three-step systems in bonding performance.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              State of the art of self-etch adhesives.

              This paper reflects on the state of the art of self-etch adhesives anno 2010. After presenting the general characteristics of self-etch adhesives, the major shortcomings of the most simple-to-use one-step (self-etch) adhesives are addressed. Special attention is devoted to the AD-concept and the benefit of chemical interfacial interaction with regard to bond durability. Finally, issues like the potential interference of surface smear and the more challenging bond to enamel for 'mild' self-etch adhesives are discussed. Copyright © 2010 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.
                Bookmark

                Author and article information

                Journal
                J Appl Oral Sci
                J Appl Oral Sci
                jaos
                Journal of Applied Oral Science
                Faculdade De Odontologia De Bauru - USP
                1678-7757
                1678-7765
                2019
                11 April 2019
                : 27
                : e20180358
                Affiliations
                [1 ]Department of Restorative Dentistry, School of Dentistry, Hacettepe University, Ankara, Turkey.
                Author notes
                Corresponding address: Fatma Dilsad Oz. Department of Restorative Dentistry - School of Dentistry - Hacettepe University Sihhiye, 06100 - Ankara - Turkey. Phone: +90 3123052270 - Fax: +90 3123113438 e-mail: dilsadoz@ 123456yahoo.com

                Conflict of Interest

                The authors declare no conflicts of interest.

                Clinical Trials Number

                NCT03415516

                Author information
                http://orcid.org/0000-0002-7450-723X
                http://orcid.org/0000-0002-7667-7494
                http://orcid.org/0000-0002-8857-2534
                Article
                00442
                10.1590/1678-7757-2018-0358
                6459227
                30994773
                59577fb8-849f-4be0-ba34-0f31352dc341

                This is an Open Access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

                History
                : 9 July 2018
                : 24 October 2018
                : 25 October 2018
                Page count
                Figures: 2, Tables: 5, Equations: 0, References: 40
                Categories
                Original Article

                dental adhesives,dental acid etching,composite resins,enamel

                Comments

                Comment on this article

                scite_

                Similar content49

                Cited by17

                Most referenced authors496