Coagulation–flocculation of aquaculture effluent using biobased flocculant: From artificial to real wastewater optimization by response surface methodology

One of the key elements in the establishment and maintenance of the biofilm structure and properties is the extracellular matrix. The extracellular matrix is composed of water and extracellular polymeric substances (EPS): primarily polysaccharides, proteins and DNA. Characterization of the matrix requires component identification, as well as determination of the relative concentration of EPS constituents, including their physicochemical properties and descriptions of their interactions. Several types of experimental approaches with varying degrees of destructiveness can be utilized for this characterization. The analysis of biofilm by infrared spectroscopy gives information about the chemical content of the matrix and the proportions of different EPS. The sensitivity of a biofilm to hydrolytic enzymes targeting different EPS gives insight into the composition of the matrix and the involvement of matrix components in the integrity of the structure. Using both chemical and physical treatments, extraction and purification of EPS from the biofilm also provides a means of determining matrix composition. Purified and/or artificial EPS can be used to obtain artificial matrices and to study their properties. Using examples from the literature, this review will illustrate selected technologies useful in the study of EPS that provide a better understanding of the structure-function relationships in extracellular matrix, and thus the structure-function relationships of the biofilm phenotype.

Polymers of various types are in widespread use as flocculants in several industries. In most cases, polymer adsorption is an essential prerequisite for flocculation and kinetic aspects are very important. The rates of polymer adsorption and of re-conformation (relaxation) of adsorbed chains are key factors that influence the performance of flocculants and their mode of action. Polyelectrolytes often tend to adopt a rather flat adsorbed configuration and in this state their action is mainly through charge effects, including 'electrostatic patch' attraction. When the relaxation rate is quite low, particle collisions may occur while the adsorbed chains are still in an extended state and flocculation by polymer bridging may occur. These effects are now well understood and supported by much experimental evidence. In recent years there has been considerable interest in the use of multi-component flocculants, especially dual-polymer systems. In the latter case, there can be significant advantages over the use of single polymers. Despite some complications, there is a broad understanding of the action of dual polymer systems. In many cases the sequence of addition of the polymers is important and the pre-adsorbed polymer can have two important effects: providing adsorption sites for the second polymer or causing a more extended adsorbed conformation as a result of 'site blocking'.