Improved synergistic anticancer action of quercetin and tamoxifen citrate supported by an electrospun complex nanostructure

The regeneration of bone tissue is regulated by both osteogenic and angiogenic growth factors which are expressed in a coordinated cascade of events. The aim of this study was to create a dual growth factor-release system that allows for time-controlled release to facilitate bone regeneration. We fabricated core-shell SF/PCL/PVA nanofibrous mats using coaxial electrospinning and layer-by-layer (LBL) techniques, where bone morphogenetic protein 2 (BMP2) was incorporated into the core of the nanofibers and connective tissue growth factor (CTGF) was attached onto the surface. Our study confirmed the sustained release of BMP2 and a rapid release of CTGF. Both in vitro and in vivo experiments demonstrated improvements in bone tissue recovery with the dual-drug release system. In vivo studies showed improvement in bone regeneration by 43% compared with single BMP2 release systems. Time-controlled release enabled by the core-shell nanofiber assembly provides a promising strategy to facilitate bone healing.

Although electrospun nanofibers are expanding their potential commercial applications in various fields, the issue of energy savings, which are important for cost reduction and technological feasibility, has received little attention to date. In this study, a concentric spinneret with a solid Teflon-core rod was developed to implement an energy-saving electrospinning process. Ketoprofen and polyvinylpyrrolidone (PVP) were used as a model of a poorly water-soluble drug and a filament-forming matrix, respectively, to obtain nanofibrous films via traditional tube-based electrospinning and the proposed solid rod-based electrospinning method. The functional performances of the films were compared through in vitro drug dissolution experiments and ex vivo sublingual drug permeation tests. Results demonstrated that both types of nanofibrous films do not significantly differ in terms of medical applications. However, the new process required only 53.9% of the energy consumed by the traditional method. This achievement was realized by the introduction of several engineering improvements based on applied surface modifications, such as a less energy dispersive air-epoxy resin surface of the spinneret, a free liquid guiding without backward capillary force of the Teflon-core rod, and a smaller fluid–Teflon adhesive force. Other non-conductive materials could be explored to develop new spinnerets offering good engineering control and energy savings to obtain low-cost electrospun polymeric nanofibers.