7
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Postoperative complication rates and hazards-model survival analysis of revision surgery following occipitocervical and atlanto-axial fusion

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Background

          Complication rates following occipitocervical and atlanto-axial fusion are high. While methods to fuse the upper cervical spine levels have evolved, complication rates and surgical survivorship of occipitocervical fusion versus atlanto-axial fusion are incompletely understood.

          Methods

          The PearlDiver Research Program ( www.pearldiverinc.com) was used to identify patients undergoing primary occipitocervical or atlanto-axial fusion between 2007 and 2017. Incidence of each fusion procedure was studied across time. Multivariable logistic regression was used to compare 30-day readmission, 30-day medical complications, and post-operative opioid utilization at 1, 3, 6, and 12 months between cohorts, controlling for age, gender, Charlson Comorbidity Index (CCI), and indication for surgery. Risk of revision was compared through Cox-proportional hazards modeling, Kaplan-Meier survival, and log-rank test.

          Results

          Cohorts of 483 occipitocervical fusions and 737 atlanto-axial fusions were examined. From 2008 to 2016, incidence of occipitocervical fusion rose 55.9%, whereas atlanto-axial fusion rose 21.6%. A greater percentage of atlanto-axial fusions were due to trauma (69.9% vs. 50.5%), whereas a greater percentage of occipitocervical fusions were due to degenerative disease (41.6% vs. 29.4%) ( p = 0.0161). Total 30-day complications were seen in 40.9% of occipitocervical fusion patients compared to 26.3% of atlanto-axial fusion patients (aOR=2.06, p < 0.0001). Risk of surgical site infection was increased (aOR=2.59, p = 0.0075). Kaplan Meier survival analysis and Cox-proportional hazards demonstrated greater risk of revision following surgery for occipitocervical fusion (log rank: p < 0.0001, aHR=2.66, 95%CI 1.73–4.10, p < 0.0001).

          Conclusions

          Rates of occipitocervical and atlanto-axial fusion are rising, while complication and revision surgery rates remain high, with occipiticervical fusion leading to higher rates even after controlling for patient characteristics and surgical indication. Spine surgeons should be cautious when considering fusion of the occipitocervical levels if atlanto-axial fusion could be performed safely and provide adequate stabilization to treat the same pathology.

          Related collections

          Most cited references18

          • Record: found
          • Abstract: found
          • Article: not found

          Dislocation of a primary total hip arthroplasty is more common in patients with a lumbar spinal fusion.

          Lumbar fusion is known to reduce the variation in pelvic tilt between standing and sitting. A flexible lumbo-pelvic unit increases the stability of total hip arthroplasty (THA) when seated by increasing anterior clearance and acetabular anteversion, thereby preventing impingement of the prosthesis. Lumbar fusion may eliminate this protective pelvic movement. The effect of lumbar fusion on the stability of total hip arthroplasty has not previously been investigated.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Three-dimensional movements of the upper cervical spine.

            Knowledge of the normal movements of the occipito-atlanto-axial joint complex is important for evaluating clinical cases that may be potentially unstable. The purpose of this in vitro study was to quantitatively determine three dimensional movements of the occiput-C1 and C1-C2 joints. Ten fresh cadaveric whole cervical spine specimens (occiput to C7) were studied, using well-established techniques to document the movements in flexion, extension, left and right lateral bending, and left and right axial rotation. Pure moments of a maximum of 1.5 N-m were applied incrementally, and three-dimensional movements of the bones were recorded using stereophotogrammetry. Each moment was applied individually and in three load/unload cycles. The motion measurements were made on the third load cycle. Parameters of neutral zone, elastic zone, and range of motion were computed. Neutral zones for flexion/extension, right/left lateral bending, and right/left axial rotation were, respectively: 1.1, 1.5, and 1.6 (occiput-C1); and 3.2, 1.2, and 29.6 degrees (C1-C2). Ranges of motion for flexion, extension, lateral bending (one side), and axial rotation (one side) were, respectively: 3.5, 21.0, 5.5, and 7.2 degrees (occiput-C1 joint) and 11.5, 10.9, 6.7, and 38.9 degrees (C1-C2 joint). The greatest intervertebral motion in the spine was axial rotation at the C1-C2 joint, with the neutral zone constituting 75% of this motion.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Anatomy and biomechanics of the craniovertebral junction.

              The craniovertebral junction (CVJ) has unique anatomical structures that separate it from the subaxial cervical spine. In addition to housing vital neural and vascular structures, the majority of cranial flexion, extension, and axial rotation is accomplished at the CVJ. A complex combination of osseous and ligamentous supports allow for stability despite a large degree of motion. An understanding of anatomy and biomechanics is essential to effectively evaluate and address the various pathological processes that may affect this region. Therefore, the authors present an up-to-date narrative review of CVJ anatomy, normal and pathological biomechanics, and fixation techniques.
                Bookmark

                Author and article information

                Contributors
                Journal
                N Am Spine Soc J
                N Am Spine Soc J
                North American Spine Society Journal
                Elsevier
                2666-5484
                07 August 2020
                October 2020
                07 August 2020
                : 3
                : 100017
                Affiliations
                [a ]Alpert Medical School of Brown University, Providence, RI 02903, United States
                [b ]Department of Orthopaedic Surgery, Alpert Medical School of Brown University, Providence, RI 02903, United States
                Author notes
                [* ]Corresponding author at: Department of Orthopaedic Surgery, Warren Alpert Medical School of Brown University, 1 Kettle Point Avenue, East Providence, RI 02914, United States. alan_daniels@ 123456brown.edu
                Article
                S2666-5484(20)30017-2 100017
                10.1016/j.xnsj.2020.100017
                8820023
                35141587
                162aa0f8-cbc3-4ccd-8f81-9f4fcd2bf313
                © 2020 The Authors

                This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).

                History
                : 5 May 2020
                : 1 July 2020
                : 29 July 2020
                Categories
                Clinical Studies

                occipitocervical,atlanto-axial,fusion,complications,revision,survival analysis,surgical indications

                Comments

                Comment on this article