Wide-scope analysis of veterinary drug and pesticide residues in animal feed by liquid chromatography coupled to quadrupole-time-of-flight mass spectrometry

After a brief introduction into the field of veterinary drugs and growth-promoting agents, the most important EU regulations and directives for the inspection of food-producing animals and animal products regarding the residue control of these substances are presented and discussed. Main attention in the review is on the methods of analysis in use today for the most important classes of veterinary drugs and growth-promoting agents viz. anthelmintics, antibiotics, coccidiostats, hormones, beta-agonists and tranquillizers. Emphasis is given to the potential, and limitations, of state-of-the-art analytical procedures and their performance characteristics. The most obvious conclusion is that, today (reversed-phase) liquid chromatography combined with tandem mass spectrometric detection--either triple-quadrupole or ion-trap multi-stage--is the preferred technique in a large majority of all cases. In the field of sample treatment, the combined use of liquid extraction--i.e., liquid partitioning or liquid-liquid extraction--and liquid-solid extraction--primary on- or off-line solid-phase extraction--is most popular. Finally, while the analytical tools required to meet the demands typically formulated by governments and international organizations today, generally speaking are available, several problems still do exist. To quote three examples, problems are encountered in the area of simultaneously extracting and pre-treating groups of analytes with mutually widely different polarities, with regard to identification-point--based confirmation of analyte identity, and regarding quantification errors caused by ion-suppression effects. Improving the speed of analysis is another aspect that should, and will, receive dedicated interest in the near future.

Ultra-performance liquid chromatography combined with time-of-flight mass spectrometry (UPLC–ToF-MS) has been used for screening and quantification of more than 100 veterinary drugs in milk. The veterinary drugs represent different classes including benzimidazoles, macrolides, penicillins, quinolones, sulphonamides, pyrimidines, tetracylines, nitroimidazoles, tranquillizers, ionophores, amphenicols and non-steroidal anti-inflammatory agents (NSAIDs). After protein precipitation, centrifugation and solid-phase extraction (SPE), the extracts were analysed by UPLC–ToF-MS. From the acquired full scan data the drug-specific ions were extracted for construction of the chromatograms and evaluation of the results. The analytical method was validated according to the EU guidelines (2002/657/EC) for a quantitative screening method. At the concentration level of interest (MRL level) the results for repeatability (%RSD < 20% for 86% of the compounds), reproducibility (%RSD < 40% for 96% of the compounds) and the accuracy (80–120% for 88% of the compounds) were satisfactory. Evaluation of the CCβ values and the linearity results demonstrates that the developed method shows adequate sensitivity and linearity to provide quantitative results. Furthermore, the method is accurate enough to differentiate between suspected and negative samples or drug concentrations below or above the MRL. A set of 100 samples of raw milk were screened for residues. No suspected (positive) results were obtained except for the included blind reference sample containing sulphamethazine (88 μg/l) that tested positive for this compound. UPLC–ToF-MS combines high resolution for both LC and MS with high mass accuracy which is very powerful for the multi-compound analysis of veterinary drugs. The technique seems to be powerful enough for the analysis of not only veterinary drugs but also organic contaminants like pesticides, mycotoxins and plant toxins in one single method.

Antibiotics are a class of pharmaceuticals that are of great interest due to the large volumes of these substances that are consumed in both human and veterinary medicine, and due to their status as the agents responsible for bacterial resistance. They can be present in foodstuffs and in environmental samples as multicomponent chemical mixtures that exhibit a wide range of mechanisms of action. Moreover, they can be transformed into different metabolites by the action of microorganisms, as well as by other physical or chemical means, resulting in mixtures with higher ecotoxicities and risks to human health than those of the individual compounds. Therefore, there is growing interest in the availability of multiclass methods for the analysis of antimicrobial mixtures in environmental and food samples at very low concentrations. Liquid chromatography (LC) has become the technique of choice for multiclass analysis, especially when coupled to mass spectrometry (LC-MS) and tandem MS (LC-MS(2)). However, due to the complexity of the matrix, in most cases an extraction step for sample clean-up and preconcentration is required before analysis in order to achieve the required sensitivities. This paper reviews the most recent developments and applications of multiclass antimicrobial determination in environmental and food matrices, emphasizing the practical aspects of sample preparation for the simultaneous extraction of antimicrobials from the selected samples. Future trends in the application of LC-MS-based techniques to multiclass antibiotic analysis are also presented.