20
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: not found

      Selective glucose conversion to 5-hydroxymethylfurfural (5-HMF) instead of levulinic acid with MIL-101Cr MOF-derivatives

      Read this article at

      ScienceOpenPublisher
      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          MOFs are also making progress in catalytic biomass transformation, here in the 5-HMF production with increased yield from glucose in low boiling solvents.

          Abstract

          The catalytic conversion of glucose to 5-hydroxymethylfurfural (5-HMF) is highly desirable, but the 5-HMF yield obtained using heterogeneous catalysts is still low compared to homogeneous catalysts, and the mechanism is not elucidated completely. In addition, the isolation and purification of 5-HMF still present a challenge as degradation reactions take place and side products form. The formation of 5-HMF from glucose has been reported using several solid acid catalysts; still metal–organic framework (MOF) catalysts could, so far, catalyze the cascade reaction of glucose to 5-HMF only in low yields of less than 16%. Glucose conversion using MOFs is little investigated and here sulfonated MIL-101Cr (MIL-SO 3H) was found to achieve 29% conversion of glucose to 5-HMF after 24 h in a THF : H 2O (v : v 39 : 1) mixture. The conversion of maltose resulted in 50% 5-HMF yield (saccharide solutions were 5 wt%). When the reaction was carried out in pure THF using MIL catalysts no product was formed, revealing the indispensability of water for the glucose-to-5-HMF conversion. Importantly, MIL-SO 3H preferentially leads to 5-HMF over levulinic acid (molar ratio 1 : 0.3), while the catalysts Amberlyst-15 and sulfuric acid form mostly levulinic acid in 5-HMF to levulinic acids ratios of 1 : 3 and 1 : 10, respectively. At the same time, MIL-NO 2 is the most selective, yielding only 5-HMF and showing no formation of levulinic acid. Using 5-HMF as a substrate did not result in any conversion to levulinic acid in the presence of MIL-SO 3H, thereby ruling out the catalytic formation of levulinic acid from 5-HMF. Catalyst recycle experiments showed that MIL-SO 3H stays porous and crystalline, but becomes deactivated through fouling by humin formation. With the use of ethanol as an alternative reaction medium, the formation of insoluble humins could be prevented, but the yield of 5-HMF and 5-ethyl-HMF decreased.

          Related collections

          Most cited references67

          • Record: found
          • Abstract: not found
          • Article: not found

          Hydroxymethylfurfural, a versatile platform chemical made from renewable resources.

            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            Conversion of biomass to selected chemical products.

            This critical review provides a survey illustrated by recent references of different strategies to achieve a sustainable conversion of biomass to bioproducts. Because of the huge number of chemical products that can be potentially manufactured, a selection of starting materials and targeted chemicals has been done. Also, thermochemical conversion processes such as biomass pyrolysis or gasification as well as the synthesis of biofuels were not considered. The synthesis of chemicals by conversion of platform molecules obtained by depolymerisation and fermentation of biopolymers is presently the most widely envisioned approach. Successful catalytic conversion of these building blocks into intermediates, specialties and fine chemicals will be examined. However, the platform molecule value chain is in competition with well-optimised, cost-effective synthesis routes from fossil resources to produce chemicals that have already a market. The literature covering alternative value chains whereby biopolymers are converted in one or few steps to functional materials will be analysed. This approach which does not require the use of isolated, pure chemicals is well adapted to produce high tonnage products, such as paper additives, paints, resins, foams, surfactants, lubricants, and plasticisers. Another objective of the review was to examine critically the green character of conversion processes because using renewables as raw materials does not exempt from abiding by green chemistry principles (368 references).
              Bookmark
              • Record: found
              • Abstract: not found
              • Article: not found

              5-Hydroxymethylfurfural (HMF) as a building block platform: Biological properties, synthesis and synthetic applications

                Bookmark

                Author and article information

                Journal
                NJCHE5
                New Journal of Chemistry
                New J. Chem.
                Royal Society of Chemistry (RSC)
                1144-0546
                1369-9261
                2016
                2016
                : 40
                : 9
                : 7958-7967
                Affiliations
                [1 ]Institut für Anorganische Chemie und Strukturchemie
                [2 ]Heinrich-Heine Universität Düsseldorf
                [3 ]D-40225 Düsseldorf
                [4 ]Germany
                Article
                10.1039/C6NJ01399F
                029d6485-8c80-4425-9494-426071192398
                © 2016
                History

                Comments

                Comment on this article

                scite_
                119
                1
                88
                0
                Smart Citations
                119
                1
                88
                0
                Citing PublicationsSupportingMentioningContrasting
                View Citations

                See how this article has been cited at scite.ai

                scite shows how a scientific paper has been cited by providing the context of the citation, a classification describing whether it supports, mentions, or contrasts the cited claim, and a label indicating in which section the citation was made.

                Similar content248

                Cited by23

                Most referenced authors1,533