Transesterification of waste cooking oil to biodiesel by walnut shell/sawdust as a novel, low-cost and green heterogeneous catalyst: Optimization via RSM and ANN

Today, various renewable biomass resources are accepted as waste material and are mostly burnt or used as cattle feed. The commercial value of these wastes can be increased by utilising them in production of nanomaterials. So, the present work was conducted for isolation of cellulose nanocrystals (CNCs) from groundnut shells which are produced annually as waste in large quantity (∼7 million tons). The structural, thermal, morphological & elemental analyses were assessed through corresponding techniques. Light Scattering studies were performed to analyse more likely weight average molecular weight (Mw) & radius of radius (Rg). The high Mw ∼105g/mol obtained for CNCs in lithium chloride (LiCl)/N,N-dimethylacetamide (DMAc) system, was an interesting feature which gets affected by LiCl and polymer concentrations. Solution with high polymer and low LiCl concentration was found to show higher values of Mw & Rg.

The low cost, eco-friendly and potential biomass, i.e. walnut (Juglans regia) shell powder was deployed for the removal of toxic methylene blue dye from contaminated water solution. The important characterization of the waste material was conducted by using several techniques, i.e. Scanning electron microscope, Fourier-transform infrared spectroscopy, Energy-dispersive X-ray spectroscopy, X-ray powder diffraction, Brunauer-Emmett-Teller surface area analysis, and Thermogravimetric analysis. The marked impact of various operating conditions, i.e. dose, concentration, time, pH and temperature on the adsorption process was investigated. Increasing pH resulted in an increase of percent dye adsorption, and the adsorption mechanism was occurred by electrostatic attraction between negative adsorbent surface and positive dye molecules. The equilibrium data suited with Langmuir isotherm model while the adsorption practice followed the pseudo-second-order kinetic model. Higher temperature reduced the adsorption of dye molecules. The adsorption process was spontaneous, exothermic and chemical. The critical statistical analysis of the experimental results was directed by forming the design of the experiment, which was further, optimized by ANOVA, 3D and perturbation plots. The error and predicted values of both the studied responses as derived from the statistical model showed the agreeable results. 0.1 N HCl was found to be effective in complete desorption. The results are very practical and prove the effectiveness of walnut shell powder in the usage of decolorization for methylene blue.