Naloxone Dosing After Opioid Overdose in the Era of Illicitly Manufactured Fentanyl

Abstract

Introduction

Illicitly manufactured fentanyl (IMF) is responsible for a growing number of deaths. Some case series have suggested that IMF overdoses require significantly higher naloxone doses than heroin overdoses. Our objective was to determine if the naloxone dose required to treat an opioid overdose is associated with the finding of fentanyl, opiates, or both on urine drug screen (UDS).

Methods

A retrospective chart review was conducted at a single emergency department and its affiliated emergency medical services (EMS) agency. The charts of all patients who received naloxone through this EMS from 1/1/2017 to 6/15/2018 were reviewed. The study included patients diagnosed with a non-suicidal opioid overdose whose UDS was positive for opiates, fentanyl, or both. Data collected included demographics, vital signs, initial GCS, EMS and ED naloxone administrations, response to treatment, laboratory findings, and ED disposition. The fentanyl-only and fentanyl + opiate groups were compared to the opiate-only group using the stratified (by ED provider) variant of the Mann-Whitney U test.

Results

Eight hundred and thirty-seven charts were reviewed, and 121 subjects were included in the final analysis. The median age of included subjects was 38 years and 75% were male. In the naloxone dose analysis, neither the fentanyl-only (median 0.8 mg, IQR 0.4–1.6; p = 0.68) nor the fentanyl + opiate (median 0.8 mg, IQR 0.4–1.2; p = 0.56) groups differed from the opiate-only group (median 0.58 mg, IQR 0.4–1.6).

Conclusion

Our findings refute the notion that high potency synthetic opioids like illicitly manufactured fentanyl require increased doses of naloxone to successfully treat an overdose. There were no significant differences in the dose of naloxone required to treat opioid overdose patients with UDS evidence of exposure to fentanyl, opiates, or both. Further evaluation of naloxone stocking and dosing protocols is needed. 

Electronic supplementary material

The online version of this article (10.1007/s13181-019-00735-w) contains supplementary material, which is available to authorized users.