12
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Effect of Surface Morphology and Dispersion Media on the Properties of PEDOT:PSS/n-Si Hybrid Solar Cell Containing Functionalized Graphene

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          We present the results on the effect of surface morphology and dispersion media on the properties of PEDOT:PSS/n-Si hybrid solar cell containing functionalized graphene (Gr). The hybrid solar cells based on SiNWs showed higher power conversion efficiency (PCE) compared to the planar based cells due to suppressing the carrier recombination and improving carrier transport efficiency. The PCE of hybrid solar cells could be improved by adding Gr into PEDOT:PSS. Different solvents including deionized (DI) water, ethylene glycol (EG), and isopropyl alcohol (IPA) were used as media for Gr dispersion. The best performance was obtained for the cell containing Gr dispersed in EG with a measured PCE of 7.33% and nearly 13% and 16% enhancement in comparison with the cells using Gr dispersed in IPA and DI water, respectively. The increase in PCE is attributed to improving the carrier-mobility, electrical conductivity, PEDOT crystallinity, and ordering.

          Related collections

          Most cited references39

          • Record: found
          • Abstract: found
          • Article: not found

          Coaxial silicon nanowires as solar cells and nanoelectronic power sources.

          Solar cells are attractive candidates for clean and renewable power; with miniaturization, they might also serve as integrated power sources for nanoelectronic systems. The use of nanostructures or nanostructured materials represents a general approach to reduce both cost and size and to improve efficiency in photovoltaics. Nanoparticles, nanorods and nanowires have been used to improve charge collection efficiency in polymer-blend and dye-sensitized solar cells, to demonstrate carrier multiplication, and to enable low-temperature processing of photovoltaic devices. Moreover, recent theoretical studies have indicated that coaxial nanowire structures could improve carrier collection and overall efficiency with respect to single-crystal bulk semiconductors of the same materials. However, solar cells based on hybrid nanoarchitectures suffer from relatively low efficiencies and poor stabilities. In addition, previous studies have not yet addressed their use as photovoltaic power elements in nanoelectronics. Here we report the realization of p-type/intrinsic/n-type (p-i-n) coaxial silicon nanowire solar cells. Under one solar equivalent (1-sun) illumination, the p-i-n silicon nanowire elements yield a maximum power output of up to 200 pW per nanowire device and an apparent energy conversion efficiency of up to 3.4 per cent, with stable and improved efficiencies achievable at high-flux illuminations. Furthermore, we show that individual and interconnected silicon nanowire photovoltaic elements can serve as robust power sources to drive functional nanoelectronic sensors and logic gates. These coaxial silicon nanowire photovoltaic elements provide a new nanoscale test bed for studies of photoinduced energy/charge transport and artificial photosynthesis, and might find general usage as elements for powering ultralow-power electronics and diverse nanosystems.
            Bookmark
            • Record: found
            • Abstract: not found
            • Article: not found

            On the mechanism of conductivity enhancement in poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) film through solvent treatment

              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Morphological change and mobility enhancement in PEDOT:PSS by adding co-solvents.

              Adding ethylene glycol (EG) to a poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS) solution improves the crystallinity of the PEDOT and the ordering of the PEDOT nanocrystals in solid films. The carrier-mobility enhancement is confirmed by using ion-gel transistors combined with in situ UV-vis-NIR spectroscopy.
                Bookmark

                Author and article information

                Journal
                Advances in Materials Science and Engineering
                Advances in Materials Science and Engineering
                Hindawi Limited
                1687-8434
                1687-8442
                2017
                2017
                : 2017
                :
                : 1-9
                Article
                10.1155/2017/2362056
                713bc177-4b64-497a-895e-10a39a8af0c0
                © 2017

                http://creativecommons.org/licenses/by/4.0/

                History

                Comments

                Comment on this article