6
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      High Throughput Field Phenotyping for Plant Height Using UAV-Based RGB Imagery in Wheat Breeding Lines: Feasibility and Validation

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Plant height (PH) is an essential trait in the screening of most crops. While in crops such as wheat, medium stature helps reduce lodging, tall plants are preferred to increase total above-ground biomass. PH is an easy trait to measure manually, although it can be labor-intense depending on the number of plots. There is an increasing demand for alternative approaches to estimate PH in a higher throughput mode. Crop surface models (CSMs) derived from dense point clouds generated via aerial imagery could be used to estimate PH. This study evaluates PH estimation at different phenological stages using plot-level information from aerial imaging-derived 3D CSM in wheat inbred lines during two consecutive years. Multi-temporal and high spatial resolution images were collected by fixed-wing ( P l a t F W ) and multi-rotor ( P l a t M R ) unmanned aerial vehicle (UAV) platforms over two wheat populations (50 and 150 lines). The PH was measured and compared at four growth stages (GS) using ground-truth measurements (PHground) and UAV-based estimates (PHaerial). The CSMs generated from the aerial imagery were validated using ground control points (GCPs) as fixed reference targets at different heights. The results show that PH estimations using P l a t F W were consistent with those obtained from P l a t M R , showing some slight differences due to image processing settings. The GCPs heights derived from CSM showed a high correlation and low error compared to their actual heights ( R 2 ≥ 0.90, RMSE ≤ 4 cm). The coefficient of determination ( R 2) between PHground and PHaerial at different GS ranged from 0.35 to 0.88, and the root mean square error ( RMSE) from 0.39 to 4.02 cm for both platforms. In general, similar and higher heritability was obtained using PHaerial across different GS and years and ranged according to the variability, and environmental error of the PHground observed (0.06–0.97). Finally, we also observed high Spearman rank correlations (0.47–0.91) and R 2 (0.63–0.95) of PHaerial adjusted and predicted values against PHground values. This study provides an example of the use of UAV-based high-resolution RGB imagery to obtain time-series estimates of PH, scalable to tens-of-thousands of plots, and thus suitable to be applied in plant wheat breeding trials.

          Related collections

          Most cited references91

          • Record: found
          • Abstract: not found
          • Book Chapter: not found

          Summary for Policymakers

            Bookmark
            • Record: found
            • Abstract: not found
            • Article: not found

            Least-Squares Means: TheRPackagelsmeans

              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found
              Is Open Access

              Machine Learning for High-Throughput Stress Phenotyping in Plants.

              Advances in automated and high-throughput imaging technologies have resulted in a deluge of high-resolution images and sensor data of plants. However, extracting patterns and features from this large corpus of data requires the use of machine learning (ML) tools to enable data assimilation and feature identification for stress phenotyping. Four stages of the decision cycle in plant stress phenotyping and plant breeding activities where different ML approaches can be deployed are (i) identification, (ii) classification, (iii) quantification, and (iv) prediction (ICQP). We provide here a comprehensive overview and user-friendly taxonomy of ML tools to enable the plant community to correctly and easily apply the appropriate ML tools and best-practice guidelines for various biotic and abiotic stress traits.
                Bookmark

                Author and article information

                Contributors
                Journal
                Front Plant Sci
                Front Plant Sci
                Front. Plant Sci.
                Frontiers in Plant Science
                Frontiers Media S.A.
                1664-462X
                16 February 2021
                2021
                : 12
                : 591587
                Affiliations
                [1] 1Department of Agronomy, Federal University of Viçosa , Viçosa, Brazil
                [2] 2International Maize and Wheat Improvement Center (CIMMYT) , Texcoco, Mexico
                [3] 3KWS Momont Recherche , Mons-en-Pevele, France
                Author notes

                Edited by: Ankush Prashar, Newcastle University, United Kingdom

                Reviewed by: Weixing Cao, Nanjing Agricultural University, China; Robert John French, Department of Primary Industries and Regional Development of Western Australia (DPIRD), Australia

                *Correspondence: Francelino Augusto Rodrigues Jr., f.a.rodrigues@ 123456cgiar.org

                This article was submitted to Plant Breeding, a section of the journal Frontiers in Plant Science

                Article
                10.3389/fpls.2021.591587
                7921806
                33664755
                6e8ea909-8e7b-4ad0-aa9d-2325c1729fac
                Copyright © 2021 Volpato, Pinto, González-Pérez, Thompson, Borém, Reynolds, Gérard, Molero and Rodrigues.

                This is an open-access article distributed under the terms of the Creative Commons Attribution License (CC BY). The use, distribution or reproduction in other forums is permitted, provided the original author(s) and the copyright owner(s) are credited and that the original publication in this journal is cited, in accordance with accepted academic practice. No use, distribution or reproduction is permitted which does not comply with these terms.

                History
                : 04 August 2020
                : 25 January 2021
                Page count
                Figures: 8, Tables: 3, Equations: 1, References: 98, Pages: 19, Words: 0
                Funding
                Funded by: Consortium of International Agricultural Research Centers 10.13039/501100015815
                Categories
                Plant Science
                Original Research

                Plant science & Botany
                multi-temporal crop surface model,structure from motion,rgb camera,dense point cloud,drones,post-processed kinematic,wheat breeding,adjusted and predicted genotypic values

                Comments

                Comment on this article