Optimization Analysis of Engine Intake System Based on Coupling Matlab-Simulink with GT-Power

There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

Abstract

In the work, the suitable volumetric efficiency is very important for the gasoline engine to achieve the aim of energy-saving and emission reduction. Thus, the intake system characteristics, such as intake manifold length, diameter, volumetric efficiency, and valve phase, should be investigated in detail. In order to investigate the performance optimization of the engine intake system, an optimization model of the engine intake system is developed by the GT-Power coupled with Matlab-Simulink and validated by the experimental results under the different conditions at full load. The engine power-, torque-, and brake-specific fuel consumption are defined as the result variables of the optimization model, and the length and diameter of the intake manifold are defined as the independent variables of the model. The results show that the length of intake manifold has little influence on the engine power and BSFC, and the length of intake manifold has a great impact on the performance index at high speed. In addition, the engine volumetric efficiency is the highest when the length of intake manifold is in the range of 240 and 250 mm. The engine BSFC improved by variable valve timing is significant compared with the original result. Finally, the improvement suggestions for the performance enhancement of the gasoline engine are proposed.

Related collections

Most cited references 6

Record: found
Abstract: found
Article: not found

Is Open Access

Effects of Swirl and Boiling Heat Transfer on the Performance Enhancement and Emission Reduction for a Medium Diesel Engine Fueled with Biodiesel

Dongli Tan, Zhiyong Chen, Jiangtao Li … (2021)

In order to improve the accuracy of numerical simulation, a new heat transfer model is developed by using a modular approach in the Anstalt für Verbrennungskraftmaschinen (AVL)-Boost software. The improved heat transfer model mainly considers the effects of the swirl and boiling heat transfer inside the engine. In addition, a chemical kinetics mechanism including 475 reactions and 134 species is employed to predict the combustion of diesel engines fueled with biodiesel. The result shows that the boiling heat transfer will occur, especially in the high-temperature area. Analysis shows that the improved model is reliable and its precision is increased. Finally, the perturbation method is employed to investigate the relatively important inputs as the complex nonlinear function with a lot of output data and input data produced by the improved model. The relative effects of different parameters such as EGR, injection mass, injection timing, compression ratio, inlet air pressure, fuel injection pressure, exhaust pressure and inlet air temperature on performance and emission characteristics are compared. The eight parameters are investigated on four outputs of brake power, Brake Specific Fuel Consumption (BSFC), NOx and HC. The injected fuel mass plays an important role in emissions and performance. The EGR, compression ratio and inlet air pressure have a great effect on the HC and NOx emission.